SamMobile was nice enough to unleash some Android 4.2.2 for the Galaxy S III Â a little bit ago. Seems that the build is still in its testing phase, and the actual update will be rolled out in June. I know a lot of you have been anxious for this, so here we go.
New enhancements in Android 4.2.2 update
– Android 4.2.2 â€“ Build ID: JDQ39
– New S4 Lockscreen: Multiple Widgets, two Unlock effects (Ripple and Light), improved ripple effect than Android 4.1.2, ability to change clock size and set a personal message
– New Screen modes (From S4): Adapt Display and Professional Photo
– Driving mode
– Actionable notifications
– New Additions in Notification Center
– Completely revamped Settings UI (Tabbed interface â€“ Exactly like the S4)
– Addition of Voice controls (Letâ€™s you control various parts of the phone using voice commands â€“ Galaxy S4 feature)
– Gallery modes have white background (When changing gallery modes to 3D the background changes to white)
– Full screen Samsung apps
– New S-Voice (from S4)
– New smart switch widget
– Found more? Tell us about them in the comments below!
– This firmware willÂ increaseÂ your binary counter but the current binary and system status will remainÂ official.
– We have re-packaged this firmware from dump files.
– There is no modem in this firmware, so the Modem you will be using before flashing this firmware will remain the same.
– This is aÂ pre-releaseÂ firmware and not official from Samsung.
– We haveÂ fully testedÂ this firmware and this firmware works perfectly as any other official firmware.
So if you want to try Android 4.2.2 on your Galaxy S III, hit the download links, and follow the directions carefully. Let us know how it is.
– Unzip the file
– Open Odin 3.04 (already included in the firmware package)
– Restart phone in download mode (Press and hold Home + Power + Volume down buttons)
– Connect phone and wait until you get a blue sign in Odin
– Add I9300XXUFME3_I9300OJKFME1_HOME.tar.md5 to PDA
– Make sure re-partition is NOT ticked
– Start flash, sit back and wait a few minutes.
– If you encounter any issues with the firmware (Any FC, Bootloop etc)
– Boot into recovery mode (Home+power+vol up)
– Choose to wipe/factory reset. (THIS WILL ERASE ALL OF YOUR DATA INCLUDING YOUR INTERNAL SD CARD!)
– Then choose reboot and you should be good to go!